Search:

Hello everyone,

So I decided to go all in on a Vertical Machining Center - I found a Bridgeport TC3G in fairly good condition that I'll be purchasing and moving into my garage in about 3 weeks. ...

So I'd like some advice - I'm looking to upgrade the motor to get 6,000 RPM, and would also like a bit more power out at the same time. I'm really considering two options at the moment:

1: VFD,...

Thanks for your reply.

So I traced the root cause down a bit further with the C10S. It only would short if I had my limit switches plugged into the board. I thought it was a circuit that had gone...

Anyone have any recommendations for a breakout board? I was previously using a C10S, but it just failed (5V-Ground Short). I'm hesitant to go with another one knowing that this one has poor quality...

I've got a few questions in case anyone has some suggestions:

1). Anyone familiar with rust problems on the G0704? I'm kind of curious if I've got a metal incompatibility with the stainless...

http://www.cnczone.com/forums/attachment.php?attachmentid=281864&stc=1

Initial Machine
Odd Spindle Noise
WhenI received the mill, the spindle was very noisy at 1,500+ RPMs. I didn't solve this...