Hey Gpena and Zdravko
Thanks for all your replays. Special thanks to Gpena – IT WORKS:) I found DNC in Operators Panel, turned the software switch on – and wupti, dripfeed is available – very very...
Type: Posts; User: Anders_K
Hey Gpena and Zdravko
Thanks for all your replays. Special thanks to Gpena – IT WORKS:) I found DNC in Operators Panel, turned the software switch on – and wupti, dripfeed is available – very very...
Hey Gpena
Thanks
Yes I found G127.5 in ladder (see attached pdf.). But to activate it, it has to be through F171.7 as I understand.
What is F171.7 and how to activate??
This is from a 0M...
Hey Zdravko
Thanks – No I did press SEARCH first ;-), so now I found G127.5 in the ladder (see pdf with picture from CRT screen – top line) It says F171.7 - Do you think, I should try to change...
TAKANG VMC – Fanuc 0M model C 1992. This is what it says in the papers. BUT at startup it says PMC: 0001-A2. So if it really is a C-model? Would like to dripfeed. I have changed diagnostic 480 bit 2...
It’s a C-model. I think the ladder is available.
Anders
Hey Al
Thanks for your fast reply. Actually the spindle is running again. I have located the problem to some pneumatic tool change problem. Maybe a sensor did not register the tool change...
Hello – first time at CNCzone.
Regarding TAKANG VMC 1991 with Fanuc 0M.
The machine has been working without problems utile now.
The spindle won’t start at all. It just stopped working after a...