Search:

To fordav11: thank you for attention.
1-contact presetter uses input X1004.2
4-contact presetter uses inputs X1004.2~5 for +X, -X,+Z and -Z directions
In my case presetter works only in +X...

Yes, I check ALL data.

Are there anybody who can help?
Machine: Mori Seiki SL300AMC
Control: MSD518 (Fanuc 18TC)
Presetter: Renishaw (1-contact)
Problem: presetter works as it is 4-contact
All parameters was set as it...

Thank you for help. I set pallet back and Set zero point works. In normal conditions you can mave any axis without pallet after M31 command. And pallet must be unclamped.
Now I have a new problem -...

I have alarm 300 n-axis need zrn
I opened/closed the door : it starts hydraulic
Pallet is removed :clamp signal is off (all axis worked without problem earlier with I unclamped pallet)
ATC home...

Do you mean door interlock release key?
No result. Not any axis moves when I switc on Set zero point valid.
What may it be?

It seems so easy, but...
Par 1815 bit APZ=0
Op.panel Set zero point - valid
Select MPG and axis don't moves

M31 (interlock bypass) don't executes in MDI mode

Is there anybody who can help...

Thanks for advices to all. It needs to set zero points so I am looking for Zero Point Adjustment SH5000-8000 instruction.

I have Servo alarm (APC) EX1664 (319).
And in manual operation do not rotating palet changer.
I am working with Mori Seiki the first time and know not so much about it.
So I need help very much.

Hi for all!
Problem:
Mori Seiki SH 5000/40 with Fanuc 18i/MSG-501 control. (APC with 2 palets)
When turning on machine, system is booting and after massege "Open and close the door" when I open...