Hello. I realized that this post is a few years old. I also use FEELER QM-22T with FANUC Series 0i controller. I was wondering if you still use this machine or have parameters for this machine...
Type: Posts; User: pmanoj
Hello. I realized that this post is a few years old. I also use FEELER QM-22T with FANUC Series 0i controller. I was wondering if you still use this machine or have parameters for this machine...
Hello,
I'm looking for parameters of FEELER QM-22T machining center with FANUC Series 0i controller. If anyone happens to use the same model or have the parameters for this machine model, please...
Hello,
I use FEELER QM-22T Machining Center with FANUC Series Oi Mate-MB A02B-0301-B801. My memory card is defected and I do not have memory backup. I was wondering if anyone here has this machine...
Hello,
I use FEELER QM-22T Machining Center with FANUC Series Oi Mate-MB A02B-0301-B801. My memory card is defected and I do not have memory backup. I was wondering if anyone here has sram and...
Thank you for your answer, jacof.
Hello,
I use FANUC Series Oi Mate-MB Controller for my machining center. I have encountered a problem after powering up. The monitor showed nothing and the keypad did not light up. I looked...
Thank you for your reply. I already checked again and there is no N 24V to supply proximity switch. Do you perhaps know where I can get an electrical diagram of this machine?
Hello,
I do not understand this alarm message code 1330 stating "MAG CTR SENSOR ERROR". What does it mean and how can I solve this problem? I use FANUC Series OI Mate MB controller and FEELER...
Hello. I'm using a Fanuc Oi mate MB Controller with FEELER machine center from Taiwan. I have a question about parameter 3404. Why does it allow only M02 but not M30? Thanks in advance, pmanoj.
Yes, I'm still using NC Link with my machine.
pmanoj
Hello, I have a problem about M30 function. I use FEELER CNC with Fanuc Oi mate MB Controller. At the end of the program, I used M02 and everything worked just fine. However, when I tried to use...
Thank you so much for your suggestion. Drip feeding finally works properly. I just enabled RTS and CTS.
Thanks again,
pmanoj
I'm using the program called NC Link and the OS on my computer is Win XP.
Thanks,
pmanoj
Hello, I have a problem about drip feed. I tried to drip feed from my laptop to FEELER CNC with Fanuc Oi mate MB Controller, however, after operating a certain number of command lines, the machine's...
Does anyone have a Brother HS-300 SERVO CONTROL PCB ASSY for sell?
pmanoj