Hello Ryadia,
I must admit you have got me worried as I have just ordered (and paid for$$$$$) one of the Masso units just a couple of days ago!
So in response to your post I went looking for all...
Type: Posts; User: sh1224
Hello Ryadia,
I must admit you have got me worried as I have just ordered (and paid for$$$$$) one of the Masso units just a couple of days ago!
So in response to your post I went looking for all...
Hello Michael,
thankyou for your response,
I feel I may owe you an explanation
I was just commenting how it was funny (sence of humour) that you asked a question and from the replies that you got...
Hello Michael
What a waste of time Micheal!
You get onto a forum and ask a simple question about an item... (warm up g code) now to me that looks like your asking for someone to help you with a...
Thanks Mactec54,
I'm going with your second option and have just ordered a relay board from EBay so looking forward to getting that up and running cause at the moment I have to get up and plug the...
HelloNleo22
sounds like you have had more success than I have with being able to run m4 as well as m3, but then again I havent tried it yet.
As for the RPM being enabled, do you mean being able to...
Hi, The spindle is Chinese as you probably guessed, it is a water cooled GDZ-80-2.2B, dia= 80 x 213, 220V, 2.2KW, 8A, 400Hz, 24000rpm,
the VFD is a Sunfar E300 - 2S0022L, 1ph 220V, 3.8KVA, 10A....
Hello again, I just had a look through the manual that ceramic man refers to... and it is different again to the one I have been using???
the main thing that stuck out to me was that it didn't have...
Hi mactec54, I don't want to start a ***** fight here but in your list you show a F2.19 well when I go from F2.10 to the next F# it jumps straight into theF3.0 set of parameters.....
just wondering...
Hello Ceramic Man....... you are the MAN in my books, the settings were spot on for the vfd. Hade to make slight adjustments in Mach 3 but other than that it' starts it stops and I can adjust the...
Hello ceramic man,
been reading your post on the e300 sunfar vfd, and can't help but notice you haven't got back with your settings.
is there any chance you can remember the settings and post them...
Hello, I'm only new to this but I could be able to help......
There should be f numbers if it's a e300 not pd numbers.
F0.0- should be 3 to give you speed control on the keypad on vfd
F0.2- should...