Hi Kjetil,
On our CV500, we have to change #6440, bit 3 to be able to use MPG for tool chain alignment.
458740
458742
I'm not sure these images will post properly - images are from cv500 tool...
Type: Posts; User: jayeff1
Hi Kjetil,
On our CV500, we have to change #6440, bit 3 to be able to use MPG for tool chain alignment.
458740
458742
I'm not sure these images will post properly - images are from cv500 tool...
mr_tetua,
we discovered the code to unlock program parameter - the code we used had to be put into #59 which unlocked the program edit function - it was an eight digit code.
We are back in...
I have a CV500 with MSC803 control. The machine has been out of service for 3 years. We've got it back up and running. The issue we have is that we cannot edit any programs. In GOP screen, when we go...
We are taking a 1998 Toshiba NX76 out of service. The machine was running fine, until last Thursday, when the spindle stator and rotor short circuited (tail bearing failure). We are not going to...
"maybe the guys that posted those have a solution ... maybe"
Thanks for the links - I missed them in my search for similar type problems
"my 1st thought when i read yours was to craft an arm...
We've asked Okuma for a solution to a problem with the rotate speed of the "Ready Station" swing arm for "heavy" tools. When a tool is identified as "heavy", the rotate speed of the swing arm from...
I just read through these posts. It brought back some memories of teletypes, yellow roll paper, black paper tape for prove outs and mylar for proven programs, using QED (quick editing device) for...
Thanks for the reply
We have a Harmatic 765, that we have struggled with interfacing on three different Hardinge model/control combinations - and have ben searching for more information on the electrical interface.
Were...
Does anyone have experience with this machine? It's a fixed headstock, bar machine with sub-spindle and a turret that is simultaneously shared between headstock and sub spindle.
Wondering if the sub...