Thanks for all the help and patience guys, I really appreciate the help!
Type: Posts; User: rayzsurfer
Thanks for all the help and patience guys, I really appreciate the help!
Tom, can I use the 16:1 at the connector with the LCTHC and verify that it doesn't spike over 35v?
Ok, now I'm confused and that is easy with electronics. So what would you recommend I use with my everlast PP50, blowback start, and the LCTHC? Will this work with what is available at the plug or do...
I hear you but I don't want to lay out that kind of cash now. I changed from the PP60 which uses HF start to the PP50 which uses blowback start. That solved a lot of my HF issues and I have been able...
Thanks for the advise Torchhead. I went with the LCTHC because of the price obviously. Is the
MP3000 the way to go? Or will the RAV4 card make this work?
Thanks John, I am going to try that. I hate to keep through money at this thing. I had left it for a few months because of the time and money I was spending on it. So I picked it up again and thought...
John, what about the torch voltage where did you connect that? Did you use the directions provided by seanmurphy or will I need one of those rav4 cards?
John I have a purchased a CandCNC LCTHC and I am trying wire it up to my Everlast PP50 plasma cutter. I have read your description and some of the other comments. Would you be kind enough to send me...
Hey tsare, saw this old posting. Do you still have your mill? How do you like it or did you get rid of it?
Nice, thanks crandolph.
crandolph I finally took a look at your videos very nice machine, my congratulations! My machine is similar, although not as nice a construction. Can you give me the details on how to add one of...
Acourtjester that machine torch that was recommended (Panasonic P-80) does not have a European style connector which these machines use.
Thanks for the response Nate. I saw your post about a straight torch. I have looked into that myself and found a supplier down in Florida very helpful. They are suppliers of the Trafimet torch. There...
The difference is that the PP50 does not use the high frequency start like the PP60. I don't know what other EMF noise may be thrown out by the guts of the machine, that was the reason for my...
Very nice machine. I have built one also using the same pieces for the gantry. I have finally got everything working but unfortunately I have a PP 60 that is throwing off too much EMF. How do you...
Thanks for the response. As it turns out I had not loaded the downloaded xml file so the gecko controller didn't know where things were mapped to on the board. My bad. It's working now. Now I just...
I am a newbie no doubt! I realize this question has been asked several times but in searching I can't find two answers that match and all of the suggestions I have read don't work.
My problem is...