thanks yes I am looking forward to trying this I need to buy my Argon and also some motor connectors for the Sanyo Denki motor. cheers Rich
Type: Posts; User: richienz
thanks yes I am looking forward to trying this I need to buy my Argon and also some motor connectors for the Sanyo Denki motor. cheers Rich
Hi, I have been lucky enough to score a couple of brand new freebie 3KW Sanyo Denko Q1 200V AC servos c/w encoders, model Q1AA13300DXS00. I am wondering whether I could run these off an Argon drive,...
I'm going to redo the tuning with a shaft lock on. I didn't realize I had to lock the shaft to do the torque tuning although it makes sense when you think about it, its just not int he VSD-XE...
yup its 940W 70VDC 18A 8 pole 1000ppr , and my psu is outputting 65VDC and its pretty beefy 1500W psi in theory so should be able to deliver the current to the motors. All my DC supply cabling is...
I'll have to check what I set it with but pretty sure it was "by the book", to be honest I have not quite figured out the filter frequency and how it impacts the tuning. Any lay mans guide or handy...
hi thanks for your response, they are 1000ppr or 4000 counts/revolution . Cheers, Rich
Need a bit of guidance please on tuning my VSD-XE drives , running a 1500w 70vdc linear psu and 940W Motionking AC servo motors.
I have set the position tuning in bench testing, the motors on...
hey Tim can I contact you please to talk about how you managed to solve your Granite Devices VSD and MotionKing motors , I am bench testing almost identical setup and having faulting on the drives....
FIXED!!!! Thanks to Jeff Birt the answer was straight forward, I had emulated estop whereas I should have used the actual pin and set it to active low. It immediately burst into life and now I am...
Hi folks, looking for some guidance here please. I am building my first mach3 based system and hit a bit of a snag. I have a small HP dc7800 desktop running Vista Business 32bit, with latest Mach3...