I am trying to do a table probe calibration. before i do probe calibration. I have everything setup and when i try to mdi the calibration it goes up and doesn't touch of on the probe. does anyone...
Type: Posts; User: JKGONZAL
I am trying to do a table probe calibration. before i do probe calibration. I have everything setup and when i try to mdi the calibration it goes up and doesn't touch of on the probe. does anyone...
I changed them today .. I thought this might fix the issue.. no luck
I have 102 servos off error, 202 302 power supply error and 649 dc bus undervoltage error..
Anyone had this issue.
I have a saw that is getting cover open errors when i try to move the jaws/clamps. changed the interlocks. still the same errors. anyone anyone??
I have a saw that is getting cover open errors when i try to move the jaws/clamps. changed the interlocks. still the same errors. anyone anyone??
i need the start stop switch for parts for Clausing CLOCHESTER 15" SERIAL 32902DD.. anyone know where to get parts for this besides clausing???
I have a deltron 10607xf power supply. Needed help, not getting the correct voltage on the outputs.
I have a deltron 10607xf power supply. Needed help, not getting the correct voltage on the outputs.
I have a deltron 10607xf power supply. Needed help, not getting the correct voltage on the outputs.
Anyone, anyone
i am not sure. i will check monday which controller. i send all the boards and board rack to mitz they check all of them. everything was ok
i can not take a picture in this building
there isn't alarm. i just will run away when i jog x. the encoder doesn't read it. i can go both directions. swapped servo drivers. also swapped the encoders on the ball screw and the motor
I have a mazak qt 35 that the x axis will not read where it is at. I have switched the encoders and the servo drive. The problem stays with the axis. Any one have any ideas??
I have a mazak qt 35 that the x axis will not read where it is at. I have switched the encoders and the servo drive. The problem stays with the axis. Any one have any ideas??
I have a mazak qt 35 that the x axis will not read where it is at. I have switched the encoders and the servo drive. The problem stays with the axis. Any one have any ideas??
I have a mazak qt 35 that the x axis will not read where it is at. I have switched the encoders and the servo drive. The problem stays with the axis. Any one have any ideas??