584,860 active members*
4,992 visitors online*
Register for free
Login

Search:

Type: Posts; User: james70818

Search: Search took 0.00 seconds.

  1. Re: Mach3 Homing to the Machine first then to the work piece

    No changes have been made to the post processor. It does this on old files that I have been running for years. I can take that same G code file and move it to another machine an it acts normal. It is...
  2. Mach3 Homing to the Machine first then to the work piece

    I have a machine that started doing this last week. I guess someone pushed a button some how. When starting, it homes everything to the machine first then it lowers the Z to the safe Z height and...
  3. Replies
    1
    Views
    1,537

    Help with routing HDPE Signboard

    So I am trying to make plaques for my son's baseball team. I am using 1/2" thick HDPE Signboard that is white on the outside and black core. When I use a 90deg V bit with a single pass it looks...
  4. This maybe a question for Gecko but I figure I'll...

    This maybe a question for Gecko but I figure I'll toss it out.

    This evening I was playing with just one servo trying to get the oscillation noise minimized. I noticed when I placed my finger on...
  5. The servos are installed on the machine. I am...

    The servos are installed on the machine. I am working with just the Y axis since it is a single drive versus the X and A. I have the power leads of of the other three drives just to isolate the...
  6. Well, with a clear head I found that it is indeed...

    Well, with a clear head I found that it is indeed the connectors I got off of ebay. Go figure. I swapped the pins and I now have motion when I jog the axis in Mach.

    Steve, I understand your...
  7. Steve, Thanks for commenting. I do have...

    Steve,

    Thanks for commenting. I do have terminal 5 and 7 jumped together on the drives. I do not have any ERR or RST going back to the PMDX-126. It is my understanding that with the Gecko g320x...
  8. Gecko 320x with PMDX-126 issue on a new setup

    Well, I am trying to get the new build moving and I'm not sure what is wrong. I am using Gecko 320x drivers with a PMDX-126 breakout board to drive Keling KL34-180-72 DC Servos with CUI AMT102-V...
  9. Replies
    5
    Views
    313

    Alex, good luck with the build. I am in the...

    Alex, good luck with the build. I am in the process of building a CRP kit as well. A little bigger but none the less the kits are well thought out and a great value for what you get. So far I have no...
  10. Replies
    1
    Views
    326

    Time to start putting a few thing together. Got...

    Time to start putting a few thing together. Got everything spread out on the table. Wow, that's a lot of parts! First I built all of the Linear Bearings and got them adjusted to the 1/4" rails. Takes...
  11. Replies
    1
    Views
    326

    James' CRP 60x96 Build

    Well finally decided to build me a router table. After looking around for a while I decided to go with CNCRouterParts.com parts kit and supply my electronics, stand, and extrusions. Placed the order...
  12. Replies
    1
    Views
    2,068

    Time for a new Controller!

    Guys,

    I have a Max NC 4 Axis Closed Loop Comtroller that I have worked on way too many times. After virtually replacing every component on the board once or twice and even more on the fets the...
Results 1 to 12 of 12