Search:

Tina I don't see anything in my email what email did u use?

Hi I am getting the same machine do you know the total power requirements for the 1325

Im in.... i would like to build a arm also please keep this thread going

hi ger21 that worked great can u tell me how to connect spindle motor single phase 110
i have it connected to the mist port is thier a better way

on my mill bearings the inner race was moveing on the bottom i used locktite
retaining fluid now thier whisper quiet

Frank

thanks for the quick reply ger21

the x is the ony axis that homes... the y and z just go to the home switch and stop it dosen't come off the limit any help is this a setting???

thanks for the help gentelman.....Steve i will try swaping stuff around

Frank Gorman

steve thanks for the relpy
http://www.protobyte.com/ but its only one motor do u think its the drive??

x axis only has a low pitch hum... same motor and drive on y axis no problem thier
can anyone help

thanks for the help Clif567 what software woud u recomend ??

Hello All i have a plc from omron sysmac cpm2a and i wan to experiment with it can anyone help me get started

Holy crap thats awsom

Hey Steve thanks for the help it works like a charm...:banana: Now im gona look this over a few times and make sure I under stand what’s happening here
I really appreciate the help thanks again

...

Al if you could bare with me on this it does not seem to switch how do you wire the sencer on the bottom if the picture to the limit on the bob
Frank

Al the device has three wires Black(gnd) Green(output) Red(Vs)

HI Steve thanks for the reply... this helps... the switch is magnetic but I think it’s the same principle, Do you have a schematic of this circuit?

Thanks again
...

thanks ViperTX .....but my knowloge of eletronics is limited this is the BOB im using http://www.cnc4pc.com/Store/osc/product_info.php?cPath=33&products_id=45
what exactly is a pulup resister

...

well i suppose its time i retracted this last statement..... not only did Arturo replace the bad board from this thread.... but his latest BOB is awsom thank you Arturo he stands behind his product...

has anybody veiwd this thread ???am i in the right forum??? or no one wants to help

After searching 11 pages I think I need help with this one I have these Vane Position Sensors need help wiring them to the BOB for the z limit on my mill the sensors have + - and output and the limit...

i just turned on the switch put the bearing on for 10 minutes it worked great

Just thought i would share this tip I am rebuilding a vaccumm pump and it needed new bearings i didn't have a press handy so i put the shaft in the freezer and the bearing on a good heater.... A...

Hi .... as i am looking for a good scope also
Hey Bob do you have a link to were you bought the Tektronix.

Frank Gorman

Anyone have an illustration on traming an enco round column mill

I Delete the G92 line and i still get a strange lead in or "starting point" in Mach3.
i realize its a Hexagon not an octagon, i just used that file as an example i realize I'm a newbie at this but...

Why do you have the G92 command? G92 was generated by Mastercamx how do i get rid of it

Hi ger21 if i run the code the machine moves from were is is to the start of the red line
Frank

Yes it is a bunch extra code its a home built router everything works good eccept for this lead in the gantry moves diagnaly then starts cutting it must be the post like gar sead now what to do about...

yes .. i want the z to plunge were i put the gantry but it follows the red leasdin and then cuts i dont know were to put the stock