Search:

I am in need of wiring schematic for a Romi Centur 35E with a Duplomatic BSV N 160/8 position tool turret and a Funuc o-t control 1992
I am having trouble with the tool turret indexing it appears...

Thank You for the information , I will let you know how it works .

I am looking to index the spindle , so the key alings with the tool changer .

I am retrofitting a maho 700 mill , my idea is to use it as a 5 axis horizontial mill and a gang tool chucker lathe with y axis milling .
I would like to be able to index for tool change and to...

How can a vfd be used to index a spindle for a tool change , is there a special type needed , encoder needed , brake needed.
How does this all work together ?

Yes I have a home routine and it is off the limit switch.
Here is the program , Thank you for helping.

x_config:

x configure: 1 amps, idle at 50% after .2 seconds

x limit cw 10000

x...

https://youtu.be/gx7NVf6xvGk
I have a video of my setup , I hope you can see where I am going wrong trying to flash program to memory.
You can see the unit working connected to the computer , the...

I think I must be doing something wrong or don't understand how to flash a program to the GM215 onboard memory. My program works in test mode with cable to computer , but I can't seem to get get it...

I have attached the entire .cbk file ( I just changed .cbk to .txt to upload it) . The proble happens often when sprial pocket cutting and when ramping into pockets the G83 was just a quick example.

When I post the G-Code from VisualMill there are at times a few redundant values in the G-Code , most controllers just pass it through no problem the CamSoft CNC Plus gives me a segment to short...

I need info on getting rs232 dnc working on this control on the back it has 2-25 pin connectors one female labled recorder the outher male unlabled what one do I use to down load programs. I have...