502,520 active members
7,217 visitors online
Register for free
Login

Search:

Type: Posts; User: quisman

Search: Search took 0.00 seconds.

  1. Replies
    18
    Views
    983

    jcplater, you will be good to go with a machine...

    jcplater, you will be good to go with a machine interface kit. The part number should be in your manual or your distributor should be able to get you a number as well. The only catch is you will...
  2. Replies
    18
    Views
    983

    Hi there, First of all I would recommend...

    Hi there,

    First of all I would recommend checking the link below.
    https://www.hypertherm.com/library/files/Manuals/Operator%20Manual%20(OM)/806650.pdf

    It's the operator manual for the...
  3. Replies
    7
    Views
    404

    You've got a PM.

    You've got a PM.
  4. Replies
    2
    Views
    375

    RCfabrication, I am sorry to hear of your 1650...

    RCfabrication,

    I am sorry to hear of your 1650 issues. It is a great machine and it cuts amazing, so I hate to hear it when an unfortunate issue occurs.
    It sounds to me like you have a defect in...
  5. Alan, very well said and great information....

    Alan, very well said and great information.
    Another good thing to test out is the pilot arc IGBT if notching/poor life is a result.
    This is a result of the machine continuing the double arcing...
  6. Replies
    2
    Views
    183

    Have you had any feedback or luck trying this out...

    Have you had any feedback or luck trying this out ?
    I am tempted to try this out if I can find some free time in our lab.
  7. Replies
    2
    Views
    183

    Energy, what type of part design are you trying...

    Energy, what type of part design are you trying to cut w/ the finecuts?
    Below is the charting one should follow for the fineCut consumable set.
    The biggest problem you will run into w the fineCut...
  8. Thread: slow cut time

    by quisman
    Replies
    6
    Views
    319

    Mark, any luck from this beauty

    Mark, any luck from this beauty
  9. Thread: slow cut time

    by quisman
    Replies
    6
    Views
    319

    Empire, Most often...if the pilot arc igbt fails...

    Empire, Most often...if the pilot arc igbt fails it will not pilot arc at all or it will continuously pass pilot current even after transfer has initiated, and you will find your nozzle to have a...
  10. Replies
    6
    Views
    556

    Naturally I am biased because I work for...

    Naturally I am biased because I work for hypertherm but another consideration is to go to a distributor and physically paw over each of these beauties. Check build quality and ergonomics which may...
  11. Replies
    5
    Views
    505

    As far as cutting lines close to each other,...

    As far as cutting lines close to each other, perhaps trying out the fine cut consumables would be an option. I do not see a listing for the material or thickness you are cutting, but if you could...
  12. Powermax 1000 misfires

    Hello all, new to the forum here and wanted to settle in with a little bit of hopeful advice. To add to Jimcolts advice.
    A couple things to try.........number 1: do you seem to have this problem...
Results 1 to 12 of 12