Hi,
Yes I contacted them shortly after my original post on here and they were very helpful. After a few hours of banging my head against a brick wall, I eventually found that a line had been...
Type: Posts; User: CncNutter
Hi,
Yes I contacted them shortly after my original post on here and they were very helpful. After a few hours of banging my head against a brick wall, I eventually found that a line had been...
I have had a similar issue with an old Matsurra. It turned out to be a door interlock of all things. Have you got one off of another machine you could possibly try, assuming your door interlocks are...
Hi Nick,
Try dropping your revs a couple hundred so you're running say 280-300rpm, increase your DOC quite substantially to say 2-2.5mm and drop your feed right down. Start of nice and low and...
Thanks for the reply. What is the standard Blum calibration cycle that is normally used? Is it BL9901?
Thanks
CncNut
You need to switch to meters per minute rather than metres per revolution. Ie. G99 to G98. I hope that helps.
CncNut
Hi all,
i wonder if anyone can help? I need to set my (X) Axis position for my Blum tool measuring system. Does anyone know where in the control I do this? I am using Siemens 840d sl on a Unipro...
I have encountered this problem myself. The reason is that you haven't got enough clearance between the end of your tool and the front of your workpiece. So as a result of this, the machine is...
Hi all,
New member from the uk here. Looking forward to learning more about the forum, contributing and helping out where I can 😊