Search:

Hello
I purchased a DM4400 with no stepper drives and installed 3 leadshine clone hss86 hybrid drives. My problem id the encoder wiring. The drive is looking for channel A+ A- B+ B- and the motor...

I also just picked up a DM-2400 finishing up the conversion since I did'nt get the programming controller. I installed a GRex with 3 Gecko 210 drives I already had and I will run mach4 on a touch...

I was interested in this equipment when it was on ebay but the bids went to high for me.
on first glance it apears you have a controller which you wont be able to use since this is basicly a...

The GRex has some advantages first if you ignore the price it has 16 inputs and 16 outputs along with 6 axis support. but if you consider that printer ports are getting hard to get on new computers...

I am in desperate need of a replacement drive gear for a Dyna Myte 2400 X axis.
Does anyone know where I can get one?
Thanks

I am retrofitting my 2400 with a breakout board and 3 gecko 210 drives.
Should be finished in a day or two. if anyone needs dyna myte drives or controller. I will be running mach3

This is my concept for laser digitizing. First get a laser displacement sensor, Ebay has all kinds fairly cheap acurate to a couple ov microns. Problem is these units have an analog output so take a...

Nice equipment there, the setup you have there is 4 servo drives and a motion control this much you know. the motion control is designed to do repetive tasks which are preprogramed into the unit via...

Just bought Rockford X-Y set with yoke retail $650.00 and the angular dearing set is $105.00 but this is not really an upgrade at least on the later style BPs but bearing headquarters is a...

Do you hav any photos of how the Z axis ball screw mounts to the quill?
or maybe a copy of the instructions, and also the motor mount.
I am doing a bp mill but I don't have standard size motors so...

I just put the Rockford Ballscrew kit in my series 1 and there a direct bolt in, however the stated acuracy is wrong its about .004 per foot not .002 but if your going to use mach3 is has screw...

Also check in the bios when the computer is booting up to see what the printer port config is, spp, epp, bi dir this will also affect performance.