Search:

You have the Z axis marked as "reversed." This would indicate to me that zero for the Z is at the bottom of the travel, and the top is -5. Since you now lower the Z to set your WCS, you have moved...

Sorry, I don't know any.

Two signals from the TC55H to the motor controller are required for bi-directional motion: Step and Direction. In the manual I found for connection, it showed a signal and gnd (pul+ and pul-) for...

Those symptoms sound like the boards are being disabled when Mach 3 starts. Do you have the EN+ and/or EN- connection on the TB6600 connected? If so, remove them on one of the motor controllers and...

When the system is powered up and you are not attempting a move, can you turn the motors' shafts easily? If not, the controller is properly holding the motors.

Were you able to get this resolved?

I ask because I'm considering the purchase of the Turnado and I'm assuming this thread is about that machine. Assuming that is the case, can you tell me what...

Looking for some feedback from someone who has purchased and used one of these. I've scoured the 'net and can't find any reviews thus far.

Thanks!

The replacement USB WIFI adapter from Tormach worked immediately upon installation.

[mjoconr]

After plugging in the wifi adapter and entering dmesg in a terminal window, the lines pertaining to the adapter are:

usb 2-1.1: new high speed USB device using ehci_hcd and address 1...

Thank you for all the responses!

I have been working with Tormach on this and they have concluded that *some* of their wifi adapters do not play nice with OS. They have found some that work and...

I have determined that the USB WIFI device is an RTL8188EU. I determined this information by plugging it into my Windows PC and checking the device manager. When I plug it into the Tormach...

Thanks for the response! I have tried two WIFI routers with the same results. I get a message in Pathpilot when I plug or unplug the WIFI USB, but the LEDs on it do not seem to blink. It's like...

Pathpilot has been upgraded to 1.9.7. I have it properly set up in ADMIN NETWORK. I have tried all the USB ports. Nothing happens--no blinking lights, no network connection. To confirm the WIFI...

PM-940M-CNC

Purchased 3/18/2016:
Table: 9.5 x 39.375; 3 slots
Axis Travel (full way support-stop to stop): X 21"-26.5"; Y 10.75"-13"; Z 17"-20"
Spindle to table distance: 1.5-21.5
Max...

I'm replacing the (foreign) electronics on a 4-axis machine. Was going to get another G540 for the job, but I could make a G214 work! ;-)

For others who might have this issue, I have solved the majority of it. The ball screw is bent/oscillating, but I have been able to remove the crunching/grinding noise.

While working on the Y...

Been fighting the Y-axis for weeks trying to get it to go in without "crunching" when turning the ballscrew to move the saddle Last weekend I took it all apart to start over. Had the saddle off and...

I am in the process of reassembling the z-axis after removing it to drill the four holes to mount the CNCFUSION CNC conversion. I am hung up on the gib adjustment. I've followed the LMS manual for...