This is a Okuma MC-V4020 2001
A travel end limit switch X,Y, or Z has been activated, Doesn't happen all the time so I know it's not System Parameter settings, Probable Faulty Cause also says,...
Type: Posts; User: machinebob1
This is a Okuma MC-V4020 2001
A travel end limit switch X,Y, or Z has been activated, Doesn't happen all the time so I know it's not System Parameter settings, Probable Faulty Cause also says,...
I've got a .625 HSS / Cobolt spot drill then coming in with a .625 HSS Black Oxide drill into 316L. What would be a good speed and feed for those.
Any suggestions would be graet,
Thank you, Bob
Yes I will, when I get home, The machine I'm talking about is in my garage not at work.
Do you mean centered, Yes, when it faces there is no nipple.
I've been making these custom bolts out of 5/8 heat treated hex, they switched up the material on me to 4140 heat treated, my roughing insert isn't lasting as long as it used to, using KYOCERA CNMG...
Does any one know how to edit the Post Processor for the OSP- P300L for a Okuma LB 3000EXII MYW, so that it only spits the program out as a Sub program.
Hello, thank you for responding back.
I'm using Fusion 360.
And why do I prefer Subprograms?
I already have the code for my approach, I can use the same code for every live tool. only have to...
Does any one know how to edit the Post Processor for the OSP- P300L for a Okuma LB 3000EXII MYW, so that it only spits the program out as a Sub program.
Thank you very much. Worked great.
Hello, I just got a Okuma EX 3000II MYW. Wrote a program to cut some jaws works great , but when it got to the M2 I got a parts counter alarm. And it will not go away, reset turn power off and back...
Thank you, very much
I have a Okuma LB 12 with OSP 500-LG controls, I running the loop program with this,
N11 V01=1
N112 V01=V01+1
( PROGRAM )
/ IF [ V1 LE ? ] N112
M2
Hello everyone,
Ive got a 1990 okuma LB 12, I cant get my unclamp light to come on, so I removed the draw bar cover were the sensors are and come to find out the sensor on the left only had one
...
Can anyone help me out with a thread milling CAN cycle for okuma. Looked through the books I have and can't seem to find it.
Yepper I found it and my machine has it in the software. do you happen to know what M-codes are used for this. I called Gosiger and waiting for a call back, nobody seems to know right off the bat.
Thank you. but how do I get to OSP Software Management Data Card.
Sorry for the stupid question.
Haas lathes have a SSV . Does Okuma have it to. I've got a LB 3000 EX
I've got a LB 3000 EX, wondering if anyone knows if there is low gear on the Mill Tool.
Hello everyone, I have a Okuma MC-V4020 that i'm trying to drip feed into, from a Hiep Phat Mechatronics DNC Transfer Device V 7.1.3 C
I know there are some peramiters to change but were are they,...