Search:

I had same thing happen to my bmc40. took the back of the screen off and inspected the pc board and noticed cold solder joints where power attaches to board. Re soldered the joint and problem went...

maxvic, did you get your problem resolved? I am having a similar problem but running x4 and my mill has an anilam 3000 control. I get the abnormal program termination error also which locks up the...

Yeah, I was hoping someone out there already had a tried and proven one so I wouldn't have to go through the dance with MC. Thank you.

I have them comunicating but after i open up the program I have so many extra gcodes that the hurco does not require, that it takes a bit of time to clean it up so the hurco will run it. Then the...

Hi, I am trying to dnc mcx4 from my pc to hurco bmc40 with an ultimax 3 control. Does anyone have a post that would work with this scenario? Thank you in advance for any help.

Well, I was checking voltage at the fuse location as it entered the machine. I didn't realise that it goes through a stepdown transformer on the side of machine and enters the spindle drive at 190 V....

Thanks Fasto for the response. The voltage statement that you said has me concerned. On the rear of the machine, it states 240 v 3-phase. I am running a phase perfect digital phase converter so I...

what does that Transistor look like? What is the root cause of that to break down? This is the 2nd time my spindle drive has went down. The first time I was able to aquire a used back part of the...

Well the problem kept getting progressively worse until the spindle blew the breaker on the Yaskawa spindle drive. I could reset it but the moment that I would try to reset the servo and spindle, it...

Looking for some help with my BMC-40. I have been getting an "Servo Driver Fault on Axis S" error when my tool is done with the cut and is retracting to make a tool change. It seems to be the tools...

I am now having the same problem with my bmc 40. Has anyone been able to correct this and if so how. Any help would be appreciated.

I have same problem. After it runs for a while 4-5 hrs., it seems the spindle has a hard time orienting then alarms out. I have a max 3 bmc40. Did you find a solution. I have replaced the magnetic...

Thanks all, just reinstalled the xml download and enable the axis jog controls.

I know someone will spot what I am missing. I am building a high percision router completed to the electronic stage. The table is 2' x 2' , will post step by step pics after I have it all done. I...

Elogicca, Pic would be greatly appreciated. I will post pics after I get it under way..Have most of the steel, have 35mm thk rails, and working on the steppers, gecko 203v,s and Rack & Pinions. ...

Elogicca, Thanks for the reply, I was hoping you were still monitoring this topic. If you could increase the resolution as you stated, where would be a good place to start? Would the change be in...

I need advise..My xylotex driver board keep shutting down in mid cut, so I have a new Mechtronics driver board that I would like to replace it with. I am running Mach 3. When I set the mechtronic...

I really like your design. My question is how did you rate your steppers, seems big. Does the 3:1 gearing work for you or would you recommend something different? thanks Rob

Hi everyone, this is a great place. Does anyone know the right way to calculate what size stepper motor I need. I am putting my list together for my 4x8 router together but want to verify the size...