Hello all,
i have defected DSP Motion board sn 415 0247 007 ( Fixed time ) and spare 415 0247 009 ( Variable time ). Firmwire version on old board is 2.09 ( U1, U2 & U3 ) and 2.10 ( U6 and U7 ),...
Type: Posts; User: Darko D.
Hello all,
i have defected DSP Motion board sn 415 0247 007 ( Fixed time ) and spare 415 0247 009 ( Variable time ). Firmwire version on old board is 2.09 ( U1, U2 & U3 ) and 2.10 ( U6 and U7 ),...
Hi,
on everything Riddersholm suggest i would add Ballbar measure, best way to see geometry status.
Darko
Hi,
do you have stabile 24V on TB1-1? You can also check connector on DCIO backplane or IO boards...
Darko
Hi,
what is full error message? Also, can you open back cabinet and look at servos, maybe you have servo error ( should be bb ).
Best regards
Darko
Hi,
this could be either HDD or memory issue. You can try to take out one memory module and try to work without it, or if you have only one then replace it with something else.
If the HDD is...
Hi,
i have similar problem, but it solved when i have downgrade from version 2.2x to 2.15. I can send you files for installation of version 2.15 if you wanna
try it out.
Best regards
Darko
Hi,
last week i had same project at my customer with flash HDD. For cloning, i use NortonGhost ( old version, portable - 5mb, i can send it to you ) but you will have problems if you wanna to...
Sorry i didnt response in time, i was away. So, you send power supply to repair?
Is this your control?
Backplane board is like a motherboard in regular computers. Should be inside your silver case, all the boards ( DSP, CPU, VGA, Canbus ) are connected in that board.
Can you please send me photos of...
Can you check red lamps on backplane board? Should be lighting red when there is voltage ( not all of them ).
POT-NOT is flashing errors on servo drives ( Yaskawa ) if there is a short-connection in limit switches or limit switch cabels. Can you look that error? Also, would be good to try measure 5V on power...
Hi,
is your PC on Hurco machine open black case or closed silver case? Anyway, i have the same problem on the old version Hurco VMX24 and the problem was console flat panel node board. But, i...
Ok, so - here are test results:
- "stuck keys" - START/STOP/PAUSE - Error is: no soft key on console is responding, not in Ultimax or in keyboard test.
I have try: replace console node board,...
We try to open back and disconnect keyboards one per time but nothing. Also, machine gives "servo fault z axis" but on servo drive there is no error ( bb ).
Hi all,
need help with BMC64 with Ultimax2.15 software. Software boots normally and then there is problems. Not one button on console
works ( machine functions, programming etc. ). We try to...
Yes, Winmax 09.xx for Mill and Winmax 08.xx for Lathe still use XP. I think you will get for Lathe 08.xx version, but it is possibility you get 09.xx ( as far as I know, 09.
is still beta version...