Neil
To clarify the problem it is only the spindle that has stopped working all steepers work ok, I just turned on and no readout on front panel, I did not use e-stop. I have checked all connections...
Type: Posts; User: palmcnc
Neil
To clarify the problem it is only the spindle that has stopped working all steepers work ok, I just turned on and no readout on front panel, I did not use e-stop. I have checked all connections...
Hi Neil
Tried to conntact you earlier in the year but no reply so assumed you were not around, but thankfully I was wrong, as you are the only one who understands the X3 mill.
Problem is no...
Is there anyone who can advise on a spindle control board on a X3, Neil who used to be on this site is no longer around so any help would be apriciated
Mike
Hi Neil
You helped me out with a problem about a year ago and problem solved, now I have a problem with the spindle speed control dropping out.
As it's intermittent it may be the big Seig...
Hi Neil
You helped me out with a problem about a year ago and problem solved, now I have a problem with the spindle speed control dropping out.
As it's intermittent it may be the big Seig...
Hi Neil
Take your time no rush, I have my mill back so am content and will not use e-stop!!!!
Regards
Mike
Hi Neil
When we Skyped you mentioned that you had designed a circuit to dissipate the load on the 10K resisters when using e-stop, could you let me have the details?
Thanks again for your help...
Neil
Re wired transformer with independent AC supply and all works, ran a program and mill performed well, so the only damage was the burnt supply to the breakout board.
Cheers
Mike
Hi Neil
Thanks for the diagram of the breakout board great help, we have progress I wired in a separate 12v AC to breakout board and led lit, fired up the mill and Mach and all seems to work. What...
Hi Neil
Thanks for explanation of the situation, but am not clear as to action, my knowledge of electronics is limited. I get a clunk when I turn on, front panel lights up and pushing start the...
Neil
The breakout board is the pic with the blue board,
Mike
Hi Neil
Have you had a chance to look into the problem with my X3? I have bought two new ceramic resistors but will wait to hear from you before replacing them.
Regards
Mike
Hi Neil
Thanks for reply here are pics of the suspect boards, I repaired the red link wire on the transformer of the breakout board but the green led does not light. Although I am not a regular...
Frying components on Syil X3 board, after a session on the mill I heard the sound of frying from the back of the machine, on investigation the two large 5W 10K ceramic resisters at the top right hand...