584,874 active members*
5,261 visitors online*
Register for free
Login

Search:

Type: Posts; User: staffordshirech

Search: Search took 0.00 seconds.

  1. Replies
    2
    Views
    725

    Re: TNC151 Monitor Dilemma

    For the record and anybody else who wants to sort this problem, I have managed to get a workable screen.
    OK, not wonderful but the old CRT screen was crap too!
    I was pointed in the right direction...
  2. Replies
    2
    Views
    725

    TNC151 Monitor Dilemma

    I have an Interact series 1 mk2 with TNC151 control and 12" CRT monitor.
    Everything has been working fine for some years now until last week when the CRT monitor decided to pack up.
    I have searched...
  3. Replies
    47
    Views
    12,064

    Re: bridgeport interact 4 spindle drive

    Just a thank-you for these posts.
    My spindle drive packed up suddenly with blue smoke........
    I have used the capacitors to the updated spec above, bought easily from Ebay.
    The drive now works...
  4. Replies
    24
    Views
    7,190

    Hi, The numbering system of two lines is normal....

    Hi,
    The numbering system of two lines is normal. Seems like it can only do 3 digits before it automatically continues on the next line.

    I have had your problem several times. Each time it is...
  5. Digging up this thread to say "Thanks". My...

    Digging up this thread to say "Thanks".
    My new-to-me machine did the same trick and had me totally baffled.
    I checked here and found this thread and solved my problem before I had the whole machine...
  6. Replies
    24
    Views
    7,190

    Sorted! Following some advice on the Cambam...

    Sorted!
    Following some advice on the Cambam forum, the problem was traced to a pin cross-over.
    Now my machine too works fine on the above settings.

    Les
  7. Replies
    24
    Views
    7,190

    Thanks from me also. I have altered all my...

    Thanks from me also. I have altered all my settings and parameters as above, checked the cable pin-out but no good..
    Unfortunately, my machine is still not speaking to the PC.....

    The TNC server...
  8. Stepper Circuit

    I tried several more technical solutions but whilst some worked OK on bench test, they didn't seem to like working on the actual machine and kept burning chips out. So I went back to absolute basics...
  9. Suitable circuit for using stepper as power feed

    Hi, I would appreciate any guidance or suggestions for circuit(s) to build a pulse generator that will enable me to control a stepper motor used as a milling machine power feed.
    My turret mill is a...
Results 1 to 9 of 9