Sorry pofo what I men't was It seems acu-rite added something to their motors that the controller needs to run them is this true also thought you might want to sell or trade for your motors.?
Type: Posts; User: grecout
Sorry pofo what I men't was It seems acu-rite added something to their motors that the controller needs to run them is this true also thought you might want to sell or trade for your motors.?
Hi pofo I have a millpwr control I need servos and glass scales do you want to sell or trade
hi pofo i have a millpwr control with no servo can I use diffrent ones
hi all I need a boot disk for my millpwr control can you tell me where to find this.?
this ? is for Marrris I have a stepper motor that has no holding torque or very little it seems to run very but no torque. this is a new system with 3 axises and X,Y run very well but Z again has...
ok I think I did what you said on Z gecko drive the 2 screws on the right side have one blue and one white wire that leads to a wire connect that holds the 100k resister, at that location I removed...
No I'm sorry all three geckodrivers have green lights and all stay on when powered up
CR no lights flashing just power light no Z axis geckodrive stays lit and it is green
CR what pins are you talking about and if they are on the gecko drive then counting from left to right #7 looks like one red wire and it goes to engage
motor switch
CR
the greco drivers are red or bergudi in color and it looks like the # G203v
Hi CR I'm not sure what gecko drives I have how can I tell
Harryn
there is no amps or MH rating on the motor,
brand new hookup,
switch to full steps ? I don't understand,
when motor is in idle and quill is down and motor is powered up I can push up on...
Harryn thanks for responce
here is the information on the motors
REX 1200 oz. in. Hybrid stepper motors with 4 wires (bipolar)
7amp. stepper motion control using geco drivers with 100k...
new to these stepper motors and running nema 34 1200oz. 7w. on a knee mill
and I have no torq. I can hold the 2" gear with my hand and try to run motor
with very little effort stall motor can...