Thanks for your input ! Yes it is using ommic sensing. When it stop cutting....we revert back to last pierce and recut the same part ....then it works fine ! Some days it cuts good !
...
Type: Posts; User: leoag
Thanks for your input ! Yes it is using ommic sensing. When it stop cutting....we revert back to last pierce and recut the same part ....then it works fine ! Some days it cuts good !
...
Hello,
Did not find the problem but I learned that it has to do with cutting amps ! The lower the cutting amps the worse it gets ! Believe it has something to do with the signal feedback from...
We have a Hyperrtherm HT400 power source on a MG table with a Burny 5 controller using shop air for cutting. Nesting software is Hypertherm Pro-nest.
The system will cut and then stop cutting for...
Voltage across pins was 120V ..... Flipped switches and relays noisy.... Connected all wires....... working !!!! unknown error....... thanks for advise
have the same problem.......Swedskar please explain : On a "normal" Burny 5 there is a input signal at 32 recp pin 11 and pin 24 that when high causes the machine to inhibit all movements . Found...
We are a small business that is looking at upgrading our system below to improve cut quality and to do some outside cutting: Pictures attached of current system.
Most of our cut work is from 16Ga...
Our plasma shop is not heated and we are looking to replace our HT400 with a HD3070 with upgraded torch, will use glicol in water for current. Have a Burny 5 controller on a Messer table. We are a...
We are using a Burny 5 controller on or plasma table. Loading and running the program is fine untill it promps you to press go for cutting.
Then under the status line you get " wait-inhibit "...