Hello all,
i've purchased this chinese tool height setter:
...
Type: Posts; User: pero81
Hello all,
i've purchased this chinese tool height setter:
...
Hi Chris, my working area is 2,5m in X axis and 1,5m in Y axis. I have set max speed at 30m/min ( 1180 IPM). I can go up to 40m/min (1575 IPM) but I don't need that much speed. About USB SS I have...
Hi Chris,
I've installed ethernet smooth stepper with C32 board on my machine. I can without problems jog machine at 30m/min with X and Y axis. I'm using rack and pinion with servo motors and 10:1...
I use Artcam 8 pro.
Peter
Mach3 mm post
Peter
Here is post and manual for editing if it will be in any help.
Peter
Hi ger21, I've tried this and when I open artcam it gives me error message:
duplicate statement found Line 53 FIRST_RAPID_RATE_MOVE = "[N] G0 Z30.00"
Peter
Hi Mike, the reason is that I use a lot of programs and if you use different dia of tools you must recalculate toolpaths. I just don't have time to edit code every time.
Peter
Hello, I have a problem with my artcam post and I can't figure out how to change it to do what I want. I want in the begining of the file first rapid speed on X and Y and then with Z.
This is how...
Thanks for answer Al. I have sent motor back to factory and I hope they will sent me new one.
Peter
Hello,
I have a problem with one of my ac servo motor and I need someone to tell me what could be wrong. Now on to the problem. I purchased 4 new sets of servo motor and drives. When I recieved...
Hello Matt, I think I've tried everything I can think of. I realy dont know what else to do. I will probably start thinking to buy some better drives and motors because of this problem and bad...
Thank you very much for answer Alan. It's 5V, 2500PPR quadrature encoder. It is original encoder. I even took all motors to service company to make sure that all signals are working and if the...
Anybody please?
Peter
Hello all, I have a problem with my servo and hope someone can help me. First of all let me introduce my system. I use Mach3 with DSPMC/IP motion controller and servo drive (sidc650) with motor...
Thank you very much. Will try that and report. Thanks.
Peter
Hello all, I need some help again. At the end I didn't replace the encoder because it works just fine. Now I have some other problem. Now the encoder is not positioned properly because it was took...
Ok I tried one of your metod and it worked. I was using a meter with one cable on minus and the other cable of the meter on the U pulse. The voltage went high (5v) 4 times in one motor revolution....
Ok thanks. Will try that and report.
Peter
Thanks for reply. Please let me know how do I look how many poles motor have. Servo shaft dia is 8mm.
Peter
Hello,
I need to replace encoder on the servo motor. I have contacted original manufacturer but didn't get any answer so I'm turning to you guys for help. I have attached two pictures of the...
In what operation mode are you running those servos?
Anyone please?
Hello, can someone please tell me how to add g41 and g42 moves into artcam post for mach3.
I have one question. I have atc spindle with two air connections for piston to release or clamp tool and one for taper clean. On first one it says piston delivery, on the second one piston retract on...
so the z-axis brake is used only when the machine is powered off?
Can you please tell me how your z-axis counterbalance works, and why are you using z-axis servo brake?
Are you still using Mach3?
It is seen from the photo that you are not using smoothstepper. Why?
.