Did you figure out how to remove the ball screw, I just finished on e and just noticed your post,
Type: Posts; User: h65
Did you figure out how to remove the ball screw, I just finished on e and just noticed your post,
Has anyone had this problem, working on a Yama Seiki GS-465 with a Fanuc Ot-I,
Lost the parameters due to dead battery, reloaded parameters, set turret position using PPM 11 and K 7.5 procedure and...
Z 70 is a position alarm = rehome
12 is a amplifier alarm
51 is a amplifier alarm
Working on a Goodway/Yama Seiki GS 4000 with a Fanuc Oi control,
Having a problem with an electrical short on the 24 volt dc side that I cant seem to locate , I have noticed on two other Goodway...
Working on a Goodway/Yama Seiki GS 4000 with a Fanuc Oi control,
Having a problem with an electrical short on the 24 volt dc side that I cant seem to locate , I have noticed on two other Goodway...
Normally, a M32 with a 600 control, after the first time that you homed all axis, the cnc should retain position after shut down, when you power back up, all you need to do is retract the turret and...
Did you loose position on all axis, I am asking because the first alarms are ABS alarm, that position, the S01 alarm is the axis tried to move and mybe went to the end of the ball screw
Worked PERFECT!! thanks Tech34
I have a 2008 Citizen M32 with a Mitsubishi 635L control,
This machine had been sitting for a year, went to turn it on and all was lost (parameters) was able to recover, but have one problem, Z3...