584,812 active members*
5,497 visitors online*
Register for free
Login

Search:

Type: Posts; User: deancnc

Search: Search took 0.00 seconds.

  1. Replies
    7
    Views
    4,033

    Re: UC400ETH Issues.

    ok Folks - pre-waning - Hijack

    I have a silly issue - it is another low IQ problem, seem to get a few of these as time goes on.

    background - have an old gantry CNC that I build - it has served...
  2. Re: SERVO-ON, ALARM RESET, SERVO READY CONTROLS WHAT TO DO?

    Ok, folks - As expected, this issue is a failed IQ test - plus a typo in the manual - in the manual, PN0096 should be 0 for CP/Dir - but the value needs to be a 1 for this setting - go figure 300...
  3. Re: SERVO-ON, ALARM RESET, SERVO READY CONTROLS WHAT TO DO?

    funny enough - Pn006 doesn't seem to be active - poking a 3 in there "should" stop the drive without the CWL and CCWL active - but the drive still operates ...so it is a lower level than that...
  4. Re: SERVO-ON, ALARM RESET, SERVO READY CONTROLS WHAT TO DO?

    sorry Dazp1976 - it takes you to a search for the manual - this link downloads it - which is the top item in that link
    ...
  5. Re: SERVO-ON, ALARM RESET, SERVO READY CONTROLS WHAT TO DO?

    Hy Guys - This is a failed IQ test type question ... and yes this is an old thread - but it looks like you have gotten past my issue

    I banged into a silly issue, I can only drive the servo...
  6. Replies
    7
    Views
    2,729

    Re: Using Vipertune with Laptop/non-com port PC

    Thanks Larry...


    This is a strange one - but this worked - I cut down the length of the cable from about a meter to about a foot - and we have contact - maybe the cable was just picking up too...
  7. Replies
    7
    Views
    2,729

    Re: Using Vipertune with Laptop/non-com port PC

    I tried the tune tool - which looked like a simple way around- but this did not work.
    I got the set of V95 from Kiling in 2011 so could be 9600 or 38400 depending on how old their stock was I guess....
  8. Replies
    7
    Views
    2,729

    Re: Using Vipertune with Laptop/non-com port PC

    Hi Guys
    I seem to have the same issue with set of Viper 95's - I have a usb serial port - it seems it doesn't matter what rate used the data on start up is gibberish - and if one changes through...
  9. Replies
    11
    Views
    720

    hey for anyone that falls over this page, and is...

    hey for anyone that falls over this page, and is weighing up Stepper v Servo...GO servo!!!

    I’ve just finished play with a new set of servos, i get good holding like a stepper, and it knows if it...
  10. Replies
    11
    Views
    720

    Thanks folks - grabbed a handful of different...

    Thanks folks - grabbed a handful of different motors and controllers from ketling - shipping was a bit over the top.

    Based in Melbourne...

    I have built a gantry mill - the table size is 1.5m...
  11. Replies
    11
    Views
    720

    Where to get cheep servos in Oz

    I grabbed some cheep a cheerful steppers and controller from Oceancontrols, but under load the max speed is just on 400mm/s. With the next step up in motor is not a nema23 frame, the next step is to...
Results 1 to 11 of 11