Thank you for all the feedback.
Problem solved with the bigger pull up resistor mentioned above, the unit performed a twelve hour test cycle last night without faulting.... I could seriously hug...
Type: Posts; User: De-Evolution
Thank you for all the feedback.
Problem solved with the bigger pull up resistor mentioned above, the unit performed a twelve hour test cycle last night without faulting.... I could seriously hug...
Hi,
Completely unsure where to put this as I am not sure exactly where the issue lays.... I have built a DIY cnc machine that somewhere along the way became much larger and more expensive than a...
Thanks for the info on Linear Technic, after contacting them they appear to be disinclined to attempt straightening as they are Chinese screws. So after all that I guess I am attempting this myself....
Oh don't get me wrong, Fred from BST was very helpful and the fact this was not found initially is my fault, I have not even tried to contact him regarding this as given how long ago they were...
Hi NIC77,
These screws were actually purchased from BST Automation as well, 10mm pitch.
I have watched most of the videos online to do with straightening bent screws, I believe I could jury rig...
These screws were purchased new a good number of months ago, they are for a DIY cnc machine that I have been slowly building over the last twelve months and only just found the bend while setting up...
Greetings,
First time posting but I have run into a bit of a pickle and could use some advice, I am in Melbourne eastern suburbs and I need to find a local shop that can straighten a large ball...