Well, it wasn't so much an issue with the machine as it was with a rather large rodent, that I still have not caught yet.
It was living in my Y axis way guard and munching on my wiring.
Thanks for...
Type: Posts; User: KaptinAmerika
Well, it wasn't so much an issue with the machine as it was with a rather large rodent, that I still have not caught yet.
It was living in my Y axis way guard and munching on my wiring.
Thanks for...
Chevalier 1418 VMC with Anilam 6000M Controller version 3.01A software
Machine booted up oddly yesterday.
Screen showed an error but the screen went blank before we could even start to read the...
Machine has been sitting for about a month or so.
Fired it up, had an issue with not booting up, turned out the CMOS battery had died, reset the date and it didn't match the time on the HDD-got...
If your still around I could so use those disks.
I need to reload my Falcon 1418 due to a corrupt command.com file but my disk 2 is also corrupt and it doesn't seem to want to read disk 1 either....
I only just got the machine so I am not real familiar with it but it is a large heavy robust machine so I imagine it can handle most that is thrown at it.
Being a 500 it has a limited table size so...
Asleep at the wheel
The machine is setup for full 4th axis with the controller.
Hi Nick
Thanks for the reply.
The only thing I have at the moment are the connectors to plug into.
I am not real familiar with the machine yet but the couple of Milacron 4th axis I have seen for...
I have a 1997 Arrow 500 and am in need of a 4th axis contouring table for it.
Thanks in advance for any assistance.
Would it still be possible to get a copy of the EZSPS program from you
[email protected]
Thank You