Mactec54 do they make any of these with edge finding capabilities, can you lay it on its side and use it that way. I'm going to purchase one and try it. Thanks for the help.
Type: Posts; User: Goo67
Mactec54 do they make any of these with edge finding capabilities, can you lay it on its side and use it that way. I'm going to purchase one and try it. Thanks for the help.
Spindle runs,stops,speeds all work thru mach3. The clip touched to the plate works as it should if spindle not in the mix.
It's water cooled. Fist thing when I opened the box was take pin jack off the top and ground spindle wire pin 4. I have continuity from spindle body thru wire. Hooked to earth from wall to earth on...
So checked all ground wireing and no ac ground and DC ground together. So back to start.
I think I have narrowed it Down to ground problem. I think Gnd and earth are meeting some where. Going to keep looking.
This shows my hookup the ground wire pin four on spindle hooks to earth on vfd prode is hooked to pin 11 and 5v on bob on the imput side.
Motor is not mounted on machine yet was just testing probe. The spindle is grounded thru earth on vfd it was the motor that turned on. I have the vfd hooked to my control box for mach3 to control...
So I went from router to spindle. With router my touch plate & clip worked fine. When I tried to put clip on end of spindle the motor took off . What is happing?......
thank you for the help i will try the switch. money very tight at the moment but will use the proper way when i can.
I have a home built cnc router that has x y z axis and just added a axis. what i do now is unplug Y motor and plug in A motor, is thier a toggle switch that will do this . all motors are 4 wire so 4...
Thank You AWERBY for your answer it got me going in the right direction. i purchased 2010 screen set and it simplified everything. thanks again
thanks, for your answer.
when i zero my x&y to material i have to use outside edge of tool instead of center of tool. is their a setting some where to change. What happens when i zero on center of tool it cuts half the...