Search:

I have a very similar issue with my 1995 Supermax Max-1 Rebel I just picked up, it’s got a Mitsubishi meldas m3 controller and I finally got the power supply from the 3ph rotary and flipped the...

Awesome thanks for the link! I tried sending you a message but it says I have messages turned off in my settings, not sure how to fix that, but anyway, I’m in the ‘New York’ US time zone. My number...

I have boards in a box marked ‘Mitsubishi Numerical Control System FCAM3A, individual boards are marked MC713/727, MC1619-1, MC303, MC301 at about navel height, then RF203, in front of an RF23, in...

Yes, I have a ton of documentation that came with this thing, including a few disks marked ‘parameter backup 2018’ I’ve also checked the battery and it reads 3.72v, so I don’t think I need a new one...

What is the procedure to reset the driver? I have a similar black screen monitor issue on my new to me, 1994 supermax mill. Thanks! Don’t want to jump to creating a new thread if your procedure to...

Sorry to revive a slightly old thread, but my a-T10B Robodrill with 16M control is having a similar issue, sat for years with a dead battery, got it up and running now, but the height offset in the...

In my Robodrill I set each tool to the top of the part with a piece of paper by jogging machine to position, then Z down just until it grips the paper, go to ‘magazine data’ table, hit ‘setup’ then...

Well disaster averted. After 10 or so failed attempts, I took apart the encoder and just looked to see if it needed cleaning or something, was clean as a whistle, but after reassembling, resetting...

So I’ve just got this Fanuc Robodrill after it’s sat for years, after powering it up, I got alarms for battery and all 3 axes needing to relearn home position. Replaced battery, powered off and back...