Hi there
Almost have my plasma table working, unfortunately the manual for my Jasic cutter has the wiring for Arc start and Arc ok back to front, and because of that it sent 12v to my torch height...
Type: Posts; User: finyuk2005
Hi there
Almost have my plasma table working, unfortunately the manual for my Jasic cutter has the wiring for Arc start and Arc ok back to front, and because of that it sent 12v to my torch height...
Yeah i have been very surprised at the power these wee servos have,
I was looking at the current monitor output on an oscilloscope while trying to turn the Z axis ballscrew with my fingers, and for...
Thanks for all the info!, i might look into them, and the delta drives you suggested
Unfortunately i dont think the dmm servo will manage,
Hi Finlay, unfortunately there is no way to increase the current resolution from the drive. The current output monitor is only meant to be...
Yeah im seeing that might be an issue indeed!
The ohmic should work fine on its own most the time, but i would like a backup in case of rusty or painted metal,
the old system used a standalone...
I am needing some help!
I have been upgrading an older CNC plasma table, using DMMTech DYN4 servo drives and matching AC servo motors,
For the Initial torch height sensing or material height...
Hi there
been retrofitting a plasma table using DYN4 servo drives and motors, through a CSMIO IP-A motion controller and Mach 3
X and Y axis proved very easy, but Y axis is putting up a fight,
I...
Hi there
Looking to replace a z axis motor and drive, but my motion controller (csmio IP/A) only outputs +-10v, because i wanted to keep the X & Y axis brushed dc servo motors and drives.
Really...
Hi there
Just annoyingly close to completing my cnc plasma table motion controller upgrade, and the last issue..(touch wood!!) plaguing me is with the standalone torch hight controller, an...