Search:

Again, it is the instruction manual that came with the lathe. The manual has 9 books and one of the books lists the alarm codes. The alarm code book has the following info:

Hyundai 1996 All...

My original post is about all the help I can offer. Its from the instruction manual that came with the lathe.

Ken

Excuse me for butting in but if you need 2 million parts per year and it takes an optimistic 20 seconds per part that is over 11000 hours per year. You haven't even started yet and you're already...

I've heard of E-stop switches going bad.
Don't know if they are NO or NC but you could try bypassing it.

Ken

" My biggest gripe is the Siemens only displays machine distance, absolute and relative are nowhere to be found, so the numbers on the display are for all purposes meaningless."

Go to "Setting...

One thing you can try is the old "P-Cancel" routine.
With the main power on and the front panel power off hold down the "P" and "Can" buttons together and turn on the front panel power. Continue...

Try holding down the "P" and "CAN" buttons together while turning on the control. This should clear out some of your problems.

Ken

Andy,

Probably not much help but my book says:
Cause: No "machine ready signal" or "hydraulic on" signal.
Action: Check breaker QFB2, QFB3 and thermal relay QFB6.
Check the "machine...

Al,

Machine was originally shipped with parameter 910 bits 1,2,and 3 set. Not sure what this means as fanuc trys to keep their option parameters a close secret. Is 910 bit 7 for the OMB or OTB? ...

Thanks Jung. Tried that with no change in problems.

Ken

I upgraded memory on a Fanuc OMB control from 16k to 128k. Reloaded all parameters and manually reentered the diagnostics. Everything looks good. The new memory is showing up as it should. Double...

Bob,

I agree with Al about the finish signal. We wanted to have a vac pump under program control so we had a friend of ours who is a EE design a box that had a 110v outlet, a connection to the...

Nope.
If you are talking about feed rate for point to point machining, the best I could do point to point was about 15 IPM for reasonably smooth motion.
Don't know if FANUC has any hardware options...

I have two of them. Whats up?

Yes, essentially we are doing it the same way just with different positions for our Z zeros. Yours at the work piece and mine at the top of the stroke. If your second tool is longer than the first...

Set your X and Y zeros with G92. Z zero should remain at machine zero (tool change position).
Bring tool one down manually and touch off work piece. Z will have value of something like -12.3434. ...

O-9999 send will send all programs.
O-9999 delete will delete all programs not protected

TFGC,
Any luck fixing this problem yet? The oldest control I have is a 3M on a 1984 Kitamura Mycenter-1. Some problems can be resolved by pressing the P key and the CANCEL key together while...

We bought our first CNC machining center in 1984. The dealer offered a programming class that lasted about 15 hours. We had no CAM programs back then and everything worked out good for us. Made...

Brian,
My advice is to find some local machine shops that farm work out. Take some pictures of your setup and maybe some sample parts you've made. Show some enthusiasm and interest in your work. ...