Search:

Of coures you'll also need to change the VFD's parameter to look for the correct input.

These files show the breakout supplying the 0-10v speed signal...

In the Mach3 Config \ General Logic Configuration, on the far right side there is a 'Spindle OV increment' setting which can be changed.

Not sure about the feed rate, but mine seems to go at...

There is one linked in this thread
https://www.cnczone.com/forums/spindles-vfd/322456-interfacing-bob-campbells-breakout-board-huanyang-vfd.html

also via the internet archive...

If it is a Joe's CNC 2006, have you tried contacting them at Joe's Cnc Home
At least one page has a 2020 copyright notice so seems still active.

If it is a Joe's, I found a link to a zip file...

My job recently purchased a KL-6590 machine.
It is equipped with an automatic lubrication pump; we were wondering the specifications or recommendation for that lubricant.

Marsha

Also in XP, in the Device Manager, for Computer, update the driver from 'ACPI PC' to 'Standard PC', you can do this my choosing the install from a specific location, and manually choosing the driver...

In the Device Manager make sure you have changed the Computer setting from ACPI PC to Standard PC and reboot, this will bypass some of the laptops power saving and timing features that can interfere...

There seems to be a partial site at www.cnc-simulator.com, but I've only been able to get the first three files listed, the first two are local to this site, and the rest still point to the site that...

This is true if just using it as shielding, but from the wiring diagrams for the driver board, it is being used as the return common for the four motor phase wires.

My first guess would be that the Open Load detection circuit is operating, i.e. the meter isn't providing the load of a real motor so the circuit is protecting the chip.

On the laptop, usually in the C:\Mach3 folder, will be a series of XML files, e.g. Mach3Mill, Mach3Turn, Plasma.

Copy whatever name you have used for your machine's profile to a jumpdrive and copy...

Could you post the page that has the pictures so we will know what we are looking for?

Switches 1-4 connect to pins 1-4 of the processor chip... only 1-3 seem to be defined for setting the microstep values.
Switches 5-7 set the drive current
Switch 8 visually is not connected on the...