It's been a few years and no one responded to your post but if you are still looking, I just bought one and I could not be happier with it. It's simple to setup and use, works great and the support...
Type: Posts; User: rjsavell
It's been a few years and no one responded to your post but if you are still looking, I just bought one and I could not be happier with it. It's simple to setup and use, works great and the support...
In case you have not found a solution for others who have spent at least a hour, like I just did, trying to solve this, the solution was to select the correct model (or at least one that supports the...
Mark,
You could use a laser, the main down side would be you would either have to sand off the burn marks or if you are going to paint, you can just paint over them. The laser burns through wood...
To follow up, I setup a volt meter and an amp meter on the laser and it reaches 8W, 4.0 volts @ 2.0 amps with the PWM set to 65%, where 50% was around 4.0 watts. I could probably run it higher but...
Wildcat and Dharmic, thanks for the great input. I'll check the current (wattage) and run some tests and see what she does.
Just for the record I have asked the seller about this multiple times...
I just bought a 15W LED 445-450nm LED laser module from eBay:
“High Power 15W 15000mw Blue Laser Head Diode Engraving Module For Engraver”
There are no instruction at all included but I have...