Hi,
i ordert now the following "3.3V PWM Signal to 0-10V Voltage Converter D/A Digital-Analog for PLC 15-30VDC" on Amazon looks like the same from Ebay:
...
Type: Posts; User: raindancer2204
Hi,
i ordert now the following "3.3V PWM Signal to 0-10V Voltage Converter D/A Digital-Analog for PLC 15-30VDC" on Amazon looks like the same from Ebay:
...
Hi akihiko,
my goal is to use my spindle speed control and turning the spindle on and off with the CNC program with the JP-3163B.
You say that these 2 functions worked for you? correct? on your...
Hi Mactec54,
it seems that he has the same setup of the hardware as me when you look at the link here: https://www.cnczone.com/forums/spindles-vfd/405148-cnc-software.html#post2386286
What do...
Hi akihiko,
you have the same main board as me? the JP-3163B. Do you also have the same frequency inverter of the type: MK100-2S1.5G-DK?
Can you please take a picture of the jumpers on the...
Hello,
From today:
when turning on the main switch on the housing, I always have about 9 to 10 volts on the mainboard pin for the spindle control.
If I increase the number of revolutions of the...
Hello,
when turning on the main switch on the housing, I always have about 9 to 10 volts on the mainboard pin for the spindle control. If I increase the number of revolutions of the spindle via...
Hi Mactec54,
i have set the bridge between SEL and 24 volts again.
Result:
It works now.
But there is one more problem:
The voltage at the frequency converter is always around 10 volts...
Hi here i found a better Manual via Google:...
Hello Mactec54,
excuse the late answer. I have now measured the voltage with the measuring device. Also through the CNC program
the volt value changes.
The jumper is also set to volts.
I...
Hello Mactec54,
if I understand the right thing, I definitely need a PWM to analog adapter between the Mainboard JP-3163B, which is then switched to the frequency inverter.
Is this correct?
...
Hi.
did you start the frequency inverter with the PC? Did you do that with the wiring? I have opened a thread for this to help others as well.
...
Hi,
i have a question for the frequency inverter MK100-2S1.5G-DK. I want to start my Spindle via CNC Software. My CNC6040 is from the Vendor "SXCNC".
Has anyone ever wired the frequency inverter...
Hello
i'm new here in the forum bought a used China CNC6040 from the vendor: "SXCNC" milling machine with 4 axis.
In this the mainboard of the type JP-3163B is installed with an additional...