584,874 active members*
5,364 visitors online*
Register for free
Login

Search:

Type: Posts; User: iBigNTastyi

Search: Search took 0.01 seconds.

  1. Replies
    2
    Views
    655

    Re: Inductive Sensor

    With different controllers, I've applied 12v directly from power source, and used resistor on signal wire to drop voltage to 5v. I plan to do the same with my PlanetCNC setup.
  2. Replies
    103
    Views
    9,076

    Re: TNG Progress

    Couple of questions...

    Are the change notes posted somewhere? I didn't see them on this forum or the Planet-CNC.com website.

    Also, if V2 is still in beta, why isn't V1 still available for...
  3. Replies
    807
    Views
    194,843

    Re: Huanyang Chinese VFD settings and manual here!

    Never mind. Reviewing the picture I took of the wiring at the VFD terminals, I can see the jumper off to the right. Can't believe I didn't notice that before...
  4. Replies
    807
    Views
    194,843

    Re: Huanyang Chinese VFD settings and manual here!

    Wait... there's a jumper too? Man, I feel like an idiot. Can you describe the location of said jumper?
  5. Replies
    807
    Views
    194,843

    Re: Huanyang Chinese VFD settings and manual here!

    Good afternoon. I have Model HY02D211B. I have successfully run the spindle via onboard controls and onboard POT. I have connected wires from PlanetCNC output board as follows:
    Signal and common...
  6. Re: Connecting Spindle and Coolant to an Output Board?

    That perfectly clarifies it. Thank you!
  7. Re: Connecting Spindle and Coolant to an Output Board?

    That's very different than what I had thought... What are the 12v and GND pins on the output board used for?
  8. Re: Connecting Spindle and Coolant to an Output Board?

    Hello,

    I am trying to accomplish the same as MaoriMan. I've currently got my MK3/4 connected to the output board as follows:
    GND to 0
    Out1 to RLY1
    Out2 to RLY2
    Out6 to S

    From what I...
  9. Replies
    10
    Views
    3,451

    Re: Connecting MPG to MK3/4

    I'm assuming V2 will also have g41/42 fixed? Will it be ported to Raspian as V1 is? Is there an ETA for release?
  10. Replies
    4
    Views
    1,253

    Re: Help cutting a 10x1.5mm

    Just out of curiosity, what if you didn't leave the leadscrew engaged? I'm trying to accomplish the same pitch, and am getting a slight cross-thread. I was dis-engaging the leadscrew, and re-engaging...
  11. Replies
    10
    Views
    3,451

    Re: Connecting MPG to MK3/4

    Mk3/4 doesn't support MPG at all? I see there's an option to use pin-outs EN A and EN B for handwheel encoder. Does Mk3/4 have pin-outs for used for MD1/2 and AX1/2? I'd really like to have a MPG...
Results 1 to 11 of 11