Hi, I am vary new to designing my first CNC. I feel like iv learned a lot, but I still feel lost. I need a long Z and there’s not a lot out there powerful enough for what I’m doing. At lest in my...
Type: Posts; User: Rkoonz2
Hi, I am vary new to designing my first CNC. I feel like iv learned a lot, but I still feel lost. I need a long Z and there’s not a lot out there powerful enough for what I’m doing. At lest in my...
Thanks for the reply, that sounds About what I read about reusing the fanuc servos. Nice to know info about not using two motors on the Z. And really nice to hear I can use the motors with any...
And just to be sure.! I should be fine using the PoKeys57CNC with these servo motors and drivers. Thanks! Rich
Awesome, thanks for the quick reply!
Hi, yes good advice!
A lot of the sculptures I cave are just big and with an 8” bit I can carve most of the profile. Iv been doing it with my old FANUC with 24” Z until it died. I prefer to carve...
I know my biggest problem will be keeping control of the huge motor, but it’s going to have to be one of those live and learn things to see if I can! Some things I just have to learn the hard way!...
Hi, thanks for the reply!
could you post a link to an example? We do have a small robotic arm, (that was expensive, don’t want to go that again) I’m sure the elbows would give out to soon if we put...
Hi, thanks for the reply!
As cool of a design as that is, it’s not as multi use as we would like it to be. I like the table because I can set jigs for different size sculptures in different parts of...
My problem is I have the 20HP spindle... I think we could get away with a 10 or 12HP but really I have no clue.
But not spending 6,000$ on a new spindle and use what we have seems like the way to...