Search:

We have about 20-25 machines that we use these to download programs back and forth to our network. They seem to work good. haven't had many issues.

Any luck on the white Auto Test screen. Our machine just powered up with it. It is very hot and humid today, not sure if that has anything to do with it. Has anyone else had this issue? Thanks

Recently sent our spindle drive in for repaire and when we recevied it back we had some issues. solved most of them but we are having trouble with three alarms. The alarms are 2213, spindle speed...

Sorry it took so long to get back. But I think I figured it out. For some reason there was a .5 in the backlash comp. I changed that to zero. And then went through a turret zero offset procedure and...

I am having a similar issue. I have a tailstock on my lb35II. When I go into system parameters I only see X and Z. No W. I hit the page down to make sure it wasn't on a different page like the Turret...

Thanks everyone. I will try and take a closer look at how much misalignment I have and may pull the turret off this week sometime. Thanks again and will update when I have more information.

I checked the clamp/unclamp switch. On my machine i have 2 proximity switches for it. Actually was fairly clean underneath the cover. Also the switches and trip dogs were clean to. Rotated the turret...

This has been an ongoing issue we have been having. Very frequently when the turret rotates and clamps we get this alarm. And basically the only way to really get rid of it is to change one of the...

We ended up sending our transducer out and get it repaired. So instead of $4200 it was about $1700. Put it in machine and set up the position and so far so good. I have done about 30+ tool changes...

We ended up calling a Service department and they found it was something with the transducer. There is a strobe signal that is suppose to change states I believe for each pocket, but ours doesn't...

Thanks underthetire.
I got price and availability for the transducer and it is $4218.56 and in stock in Japan. You are confident you have come across a similar problem before. My boss is just a...

I have been having this issue for sometime now and cannot seem to figure it out. The issue is that only sometimes when you call up a tool the magazine rotates and it will rotate for up to 45 minutes...