Search:

I do not have any backups currently. I will attempt to access the information and get back to you.

What type of battery and where is it located?


Jason


Sent from my iPhone using Tapatalk

Not sure how I miss the reply’s to this.

This issue only shows up when doing a X minus move. The belt is tight, I had the x axis run away on me and smash the x servo bracket into the saddle and...

I am having an issue with the x axis servo on my Fagor 8055i-mc equipped ACRA knee Mill. when the Mill is in DRO mode the X Axis is smooth when the x axis hand wheel is turned. when the CNC is active...

did you Find a solution to this Problem? Our EZ trak is currently doing the same thing and I am having my Employee restart the mill to see if it will get him back working.

Jason

I do believe the mill is around a 1991. The Keyboard still works. I can write a program and change screens you name it. I can move the table with the hand wheels but the position readout does not...

I went to use my company's EZ-Trak DX this morning and it was giving me the message that it was not homed, I tried to home the machine and gave me a Power Error. I restarted the machine and homed it...

the rapids are limited on our TM3 due to it being an open machine, (at least that is what i am being told).
We ordered the M-FIN Adapter and the plan is to have the machine rapid down, activate the...

the PDF that KenFoulks posted is helping, I will have to do some investigating on our machine to see if the M-Fin is installed.

Tim,
The probe option will add time to the cycle, But thanks for...

Geof,
My impression was that the M21 is an output?
Where would you connect the signal back to the machine?
our operator loads one fixture while the other is being tapped.

I like your Idea of...

Ken,
I can see where you are going with that but the tool changes on the machine is slow. This is a Cycle time thing, there are 2 fixtures that hold 8 parts each, Tapping a 1/4"-20 hole. I think...

Does any one know if it is possible to add a sensor to a TM3 to check if a hole is there before it is tapped?

The seeing the hole part is easy, but is the machine capable of accepting the input?
...