Well after digging in a little deeper both Fanuc and Hardinge tell me its an encoder issue. I have one headed my way now. I will post if this fixes the problem.
Thanks,
Micheal
Type: Posts; User: MVIL
Well after digging in a little deeper both Fanuc and Hardinge tell me its an encoder issue. I have one headed my way now. I will post if this fixes the problem.
Thanks,
Micheal
mbservice,
I'm not completely sure I understand the "standard Fanuc A or B"
On the first page that allows me to setup which increments to use metric or inches I have inches selected.
What I...
Superman,
Thanks for the info. I will try it out.
Jim, i think the correct parameter for canned threading is 901-7. i do have that one. I did notice later last night that the actual spindle speed wasn't displaying correctly. When 1500 rpm was...
Howdy all,
I have a feed rate problem that is driving me bonkers. I just powered up and new to me an early 90's model conquest 42 with an OTC control ten station turret with live tooling and...
howdy,
Does anyone have a list of the spindle parameters and analog spindle tuning instructions for a Hardinge conquest 42 OT-C. It has subspindle, live tool, 10 station turret. I don't know if it...
Can you send me the nikken setup sheet? I have the same servo motor but a omc control and I need to change the gear ratio.
Thanks,
Micheal
- - - Updated - - -
Can you send me the nikken...
OC,
I purchased the Kiwa and use it daily.
I have had it for about 1-1/2 years now and just this weekend I got the 4th axis to work. Not fully with G01 but it positions and homes out with G00. the...
Hello all,
My first time posting. I have been reading for a few years now and it is really nice to see folks helping each other when one has a need.
Well, now I have a need. I just bought a 1990...
Howdy all
My first post.
I have a supermax with a dynapath 20 control and I'm having axis gain/loss issues. Over 18" in the X axis I loose 0.0107" I have .0006" backlash compensation. From...