I think this is what you search, this laser I saw-it work: Spartacus - Laser cutting Machine for Laser Cut, Laser Engraving and Laser Marking
Type: Posts; User: dorinspeedy
I think this is what you search, this laser I saw-it work: Spartacus - Laser cutting Machine for Laser Cut, Laser Engraving and Laser Marking
I d'ont know what sources of motors you may have, I will use on X axis, 2 motors with 3Nm and the same on Y axis, on A axis (tangential) 1.5-2Nm, drivers independent on each axis ones with 4-5Amps...
Welcom to Forum!
You may inspire from Mech Mate projects, only for fabrics, you make a machine much lighter, depending on fabrics you want to cut, is necessary a vacuum table and a tangential...
I think there is an issue with PSU of the laser and/or with controller of the laser, somehow one or another d'ont get or sent the right signal, on or off, at the right time.
While cutting work well,...
In some place you have a switch Manual-Automat, this let you to choose laser Power and other things on software, in manual mode it work with settigs from display, in automatic with settings from...
Check filters on pump absorbtion and direction of rotation of the pump.
I have do this, move all filtering/drying in compressor room after receiver, increase presure at compressor at 8 bar and use at point of use pressure regulators/filters. Don't mater how low or high...
Is the pipe underground, what is diameter of the pipe, do you have some moisture removal device near receiver, what is air consumption at plant B?
If your Kcam is demo version it has a limited number of lines for G-code, buy full version...
with knife cutting is no way to eliminate overcuts or minimize it with a cutting knife with a minimum angle that cuts your material or you may try water cutters
I don't know what machines you test,...
I have only this if helps you
No way to cut leather on a plotter made for vinil, if you have or buy a plotter cutter with tangential osscilating knife and for holding the material on the table you need a vacuum pump (see for...
For fabric I use in a shoes factory one CNC machine with oscillating tangential knife, fabric its held by vacuum (see Zund, Lectra, Gerber, Comelz, Teseo, only for documentation, these are expensive...