If the torch makes contact with the plate and continues to slowly raise up, this means it is still detecting ohmic and trying to lift off the plate to break the circuit. Could be debri in the shield...
Type: Posts; User: Dennie
If the torch makes contact with the plate and continues to slowly raise up, this means it is still detecting ohmic and trying to lift off the plate to break the circuit. Could be debri in the shield...
The VFC box is polarity sensitive, it will only read voltage in the Auto mode. If in Auto it displays 0 voltage when cutting try swapping the arc voltage wires.
You dont need to make any changes in the VMD software to cut a metric file, in VMD leave everything in inches you can change the Viewport to Metric by Logging on as Admin, click the small Gear icon...
Still not quite sure what you are describing you tell me it drops down the the same height as 1/4" material then times out, but you don't mention if it comes down and touches the plate first and...
When you say it can drop all the way to the top of the slats, how are you doing this, are you using the Jog Slide feature on the AVHC box or are you using the Aux Menu and pressing the Plasma Off...
You do that by cutting a slat support bracket that runs down the center of the table and you offset it one tooth so that when the slats are inserted they are bowed out a little putting tension on the...
I can suggest the HT 45 and in this case you get what you pay for, the HT 45 takes all the guess work out of cutting with plasma you can look in the manual and refer to the cut charts for all of...
To clear this thread up the 750 motor is a smart motor, which is a servo motor and is the reason why it is so expensive compared to a normal stepper.
If you are burning the cables you might want to look for a more hear resistant cable, the connectors are standard mini fit Jr. You can make these cables very easy yourself if you have the right...
Good choice the PM45 is a great plasma cutter.