Millwright79 you are correct in that you will need to pull the spindle motor off and then raise the tranny. You then need to pull the shifter solenoid out and pull it apart and clean it. Source some...
Type: Posts; User: sagespecialized
Millwright79 you are correct in that you will need to pull the spindle motor off and then raise the tranny. You then need to pull the shifter solenoid out and pull it apart and clean it. Source some...
All manual input on that control.
This position is still available if there is any interest.
Thanks,
I just put on a new style z axis cover on one of my old 90' models last year, they don't come with instructions.
Pull all the screws out of the rails holding on the old one. Clean and reinstall...
Sage Specialized is looking for a cnc machinist to help keep the spindles turning.
We're a young company that started in the garage and now have expanded into our own space. As of last night we...
Hello,
I sent you a PM.
Thanks,
B axis motor issue...my bad I was thinking pallet changer for some reason, sorry.
I'm thinking X,Y,Z,and B all have the same amp in the cabinet. You can tell by there Fanuc model numbers, if that...
On the outside forks that hold the pallet there is a pallet confirmation switch that is activated when the pallet is set onto the forks. There is a cover on the side that you can take off to gain...
Drop the tool change door in MDI with the M code listed on the cheat sheet they are usually magnetized to the side of the machine.
E-stop the machine so you can crawl into the space where the tool...
Have you checked the cable to make sure all the wiring is in good condition. I know the motor cables are snaked and have a half coil in them to account for the rotation of the pallet changer. This...
Pm sent....
Thanks,
Hi Thinwater,
I sent you a PM.
Justin
The drawing I drew was an example of how I document which direction and how many washers stack up that way. It was not correct in how many were stacked etc...that needs to come from inspecting each...
Alignment could be an issue...
I have also ran into situations where the pins in the S arm that holds the tools in position during a change had chips smashed in them. These pins are spring loaded...
I have done a few of these...
Pull the drawbar and take a measurement of the total stack up length at compression, write it down.
I lay a big piece of cardboard out to draw on. As you take each...
Wow man. Good looking art.
I am a professional machinist in the aerospace sector. Been at it 25yrs. I was thinking I could set up a cell of these little machines for the right parts and save a...
Hi,
I'm new to join but have been wandering around here for years.
I have a 9 x 20 HF sitting here in the garage, still in manual mode.
Can you guys give me some real world performance numbers...
Hi Muzzy,
I sent you a pm.
Thanks,
Hi Folks I posted up a request for programming help in the employment section.
If anyone is interested take a look.
Thanks.
I'm in need of a part time Onecnc programmer, or someone with the software that can program from home then send me the file, setup sheet, code etc.
Prefer someone in the pacific time zone to...
mikemike^3
I sent you a PM.