Hi there,
I just installed a new spindle, 2.2 kW water cooled, Chinese.
Before using it I made it run at low speed for 2 hours and then increased the speed gradually.
I have a funny noise between...
Type: Posts; User: FeliceM
Hi there,
I just installed a new spindle, 2.2 kW water cooled, Chinese.
Before using it I made it run at low speed for 2 hours and then increased the speed gradually.
I have a funny noise between...
Beginner question.
I made and test a tool path of a relieve on my machine. I am using Artcam pro 2017 and Mach3.
I have two tool paths, roughing and finishing.
When I run the second one...
Hi there,
I just started using Artcam 2017and I have Mach3 with a manual tool change macro.
I noted that Artcam does not allow to save multiple tool paths with different tools with Mach3 post...
I have checked the minimum system requirement for Artcam 2017 and accordingly a minimum display resolution 1980x1200 is required.
I am trying to choose a laptop to install Artcam and the maximum...
Thank you. Your advice is appreciated.
I am using the latest stable version 0.9.8
I did some test and I discovered that the issue is caused by the Roughing/Finishing setting. I was using "finishing" straight away and this cause the...
Thank you for your hints. Will try.
As far as cncerning the Cambam forum I have experienced quite a lot of ego going on there.
Hi there,
I just started using Cambam and it is my first experience with a cnc milling machine. I built my own one and I am using Mach3.
I have already experienced some machining with simple parts...
Thanks for your opinion. Now that you say that I agree.
Hi,
I am new on the forum and I hope this is the right section for this question.
I have recently completed my first CNC machine starting from scratch after some experience on building few 3d...
Hi There,
I just joined this forum. I have recently completed by first CNC machine and I would like to learn and share experiences.