Search:

Hello, by mistake I've changed NC ethernet interface to DHCP, now machine doesn't run.
Are there any default settings for this interface or is there any way to see somewhere old settings?
Contoller...

Hello colegues,

I do not know it it is right category, but I am a bit dubt so I need to ask question :)
So can somebody explaine if there are any diferences between mentioned threads?

I do...

Hello, I am new on this forum, and hope someone can help me to resolve the problem we have with Hwacheon HI-ECO45 machine.
Suddenly it refuses to rotate the turet and move tailstock "tube". When I...

Hi,


I am beginer on 5 axis programming with mastercam, and recently had a problem how to make a programm for milliing the thread on the cylinder.
Problem is the item size and it calls some...

Well,
kurmay thanks for your advice. I have read other threads on this forum and as far as I can see only way to make backup copies of the programs from this machine, is to buy floppy-usb...

Well, that could be a challenge, even I dig deep in the boxes in the cellar I do not think I can find any ploppy disk. But even so I do not have any floppy drive in the computers.
There is no way to...

Thanks for the reply, if so what way can I transfer dhem to the computer?

Hi use M2 insted of M30

Dear colleagues.
,
First of all I am new on this forum and would like to say hello to the comunity.
I am writing here due to the little annoying problem I have when perform transmision between NC...