Search:

manual is not a big thing
u just tell are u operating the machine properly?

Ravinder

i think also every walter grinder is busy

hello ali
i hv operating manual of the tnc 355 but how can i send it to u coz i dont hv ur address and secondly it will be costly for send to u if u hv any specific problem for operating the machine...

yes

i used tnc 355 for years ago
i was using dnc softwer TNCNAMO
and using its own language for programming
we was doing on it tool dies and mould work

hello ferroma
i hv some material of baldor drives i will send u later

Ravin

okey
if you can send me pic of the controler and serial number by mail then may be i can arrange some help for u
[email protected]

hello this is not a major alarm

just reset overload relay if the servo amplifier

switch off from the main before reseting the thermal relay


Ravinder

hello eric i am online so u can discuess with me now in the chat room

hello Eric
which controlse u r using? if u hv play in z axis ball screw or not
u can compensate

Ravin.

Basically i am an electronics engineer but due to hobby i learn about cnc operating and programming in 2000
and now i i am cnc INCHARGE
and now i am learning about cnc retrofitting

ok
my mail id is [email protected] send me which values u r putting in controler and how i think u r doing same in all axis
but some code also change according to axis

what wrong Stevie?

which procedure u use by manually through controler
or through computer?

only setting are changed in machine parameters

we hv 5axix walter tool and cutter grinder
for resharpening ball nose cutters
and we are making new also and now we are looking for coating

hello i am Ravin
which manual u need for mazatrol T2

you r right shivaraj

the Floppy drive used on the controller is not compatible with the standard pc floppy drive

but you can note all the system parameters manually

ok
can u tell me in datail ur problem

hello Ghyman
i seen ur model but i didnt underestand what u wants to built up?

u are telling that ur machine gives u massage(You must enter the backlash table. Jog axes to home then enter the CS command. No parameters or parameters corrupted. you must enter the setp command....

hello
can u tell me what problem u r facing exectally in cold start
and what hapened to ur machine

do u collect all the information about it?
if u did and u r going to start thats good
and if u didnt then first of all collect maximum infomation for ur hobby project


Ravin

we hv a used...

u can use TNCREMO DNC SOFTWER

which Fadal u r going to purchase
machine is good no doubt but machine wants extra care then others

yes but i m new in cnc manufacturing and i m collecting reliable and price comparing parts

tulak
i wants to chat with u on this topic

did ur slides moter tuning is properly if not then tune the axis of the machine

visit once a day in chat room

Bulle tx magnet
u told that u hv 2d dxf file
but i think ur machine cant read dxf format
machine reades only machine language
so u can use any cam softwer using in wire EDM machine
it will...

Snjor. why not i wants to trial and wants to see what is new in this