Thanks Matt...seems to be what I am coming up with...
Type: Posts; User: cnctech
Thanks Matt...seems to be what I am coming up with...
I am looking for some 12L14 in flat bar sizes: 1.75 X .75 and .75 X 1.00 does anyone know where to go for this?
Thank you!
This is the first time I have dealt with this metal. I am needing some 41L30 Steel in flat bar .5 X .75 X whatever length...or possibly ripped from a plate. I can find 4130 but I am having trouble...
Thanks...I'll check them out.
The ruffers are I believe ONYX brand, REF 7644 PMX TIALN 1/2 X 1/2 X 1 1/4 X 3 1/4. They are a 4 flute powder metal ruffer made in spain. I have been getting them for years and they are the best I...
My current depth is .625" in 7075 and 1018 cold rolled as well. I will have to check times again on both materials. Its pretty fast I just though there may be a better way or new tool on the market...
Currently I am using an indexible boring bar to bore a 30mm hole + or - .0002... Beings this is the only size hole I am currently boring I am wondering if there is a different tool to use that may...
I have a 4020a and when I power down the machine at night the z axis slowly falls down...any ideas as to what is causing this??
Thanks for the input...the problem ended up being the big blue capacitor that feeds power to the cards...didn't even have to replace the card...but ended up spending a bunch of money then finding out...
I am having a problem with my oldest fadal. Its a 93 Fadal vmc 2016. About week ago I had a servo amplifier card fault show up. Standard operating procedure is to swap cards around and if problem...
Thanks Andy. The bearing block is the one that the chiller runs into at the motor end of the screw. The plastic bushing I was referring to come to find out is called a sweep which is located on both...
I have replaced the x and y bearing blocks on a fadal 4020a. While inspecting the blocks it looks as though you could replace the seals and they both would be fine. Does anyone know who carries these...