Search:

something to look at , will give it a shot. But why will my X and Y run ok..????? Appreciate your help..Thank You

z moves in the software, on the computer screen in mach 3, but motor Z Does not move..when running the roadrunner in demo mode.I can't help but think that I have an issue with the settings in mach 3,...

Novice or rookie trying hard. Believe I have everything wired up correctly , running mach3 in demo . Load the sample g code that mach3 offers, code is running on computer screen, x and y doing their...

got lucky and got the X & Y set up with mach 3 demo..entered the sample Gcode from Mach 3 and was able to go through the motions on the computer and had the motors set up on top the table and it...

mach 3 stated it should run in demo mode, but code was limited..I figured I would try it , since I'm not sure if I can fulfill my duties building it before I go nuts..LOL

i just order and received a Dell Optiplex 380
from ebay..seems to work fine
Windows Pro 7 with 32 Bit
Parrallel port installed or came with it
Motors and drivers along with board and 25-Pin...

Appreciate the information. Took me a few minutes, but I got 4 images uploaded..I probably need to get some good wiring diagrams and start from the beginning..
Little confusing for me, but would...

I'm a newbie to this stuff and this forum. so please bare with me and make explanation simple to understand for an old 62 year old fart

I need some help with configuring my drivers and wiring for...