Hi - We are laser cutting a lot of plywood. From time to time the machine has to be cleaned. The construction of the machine has had no input/help for this. It is always very time consuming....
Type: Posts; User: dhei
Hi - We are laser cutting a lot of plywood. From time to time the machine has to be cleaned. The construction of the machine has had no input/help for this. It is always very time consuming....
Sorry for being late - you're too far away - all the best
This was a big issue and I have had to get support from the chinese manufacturer. Where are you located? I can send you some photos, but - there are certainly differences in hardware. I do not have...
We are also troubled with this y-offset phenomenon and we would also like to replace the leetro controller. Have you been successful in replacing and tightening the ribbon? Could you advice me how to...
Have you replaced the MPC6515 controller? Can you please tell me some details etc. to avoid problems. I am in the same situation (LC1390N).
Thanks
We are running a 100W plotter laser to cut and mark (decoration) 3mm plywood. I guess that our laser is too powerful for fine marking, because its traces are too deep. I also would like to get things...
Have you found the solution? It seems that I have a similar problem. TIA d
We're running a GWeike laser now about half an year. All of a sudden the machine does not properly realign the y-axis. Cuts which should be at the same height get a difference of up to 3-4 mm. We...
The machine feet are well placed on the floor? Try to reduce the speed of the xy when not engraving - any difference?