Search:

Thank you zavateandu,

It is Fanuc 15-TTA control. The machine is Seneca Falls Model CD-600 .
4 Axis Hollow Spindle Lathe.

Hi everyone,

I am looking for an old machine parameters backup, Can anyone tell me are those 9000 parameters ?
And how can I check or read 9000 parameters? how to know those parameters are lost?...

According to the manual, zero return is simple: first , press jog button, select desired axis "-" off the switch; then, press home button, move the axis...If it is an interlock problem ,do you think...

I just tried holding P+cancel while power up and continue holding them, and i still cannot select axis, X1 X2,Z1 Z2, those lights are still flashing. Thank you.

we have tested set feed rate at 25% 50% 100%?still does not move.
Thank you.

it is the video when the machine power up.

home required from the manual

Thank you. In the manual it is easy to home the axis,( i attached photo), but the axis does not move. I have followed some homing procedure from internet, liking set 1815 APZ to 0, then to1....,but...

Thank you. I test Emergency stop is good. and I believe "reset" is good, it can reset other faults. I do not know how to test "not ready" signal.

Thank you. Parameter is 0. but i do not have parameter list.
’‘

Thanks for replying.
So is it a parameter problem?

Hi everyone!

I am new to a Axis Hollow Spindle Lathe with Fanuc 15-TTA Control.

The operator told me they changed the battery this April, at that time there was an alarm SLC ERROR 84 , but...